LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2014 >> GL63 AMG >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Engine Cooling System - Maintenance) >> Engine Cooling System - Maintenance >> Check main circuit coolant level - AP20.30-P-2050CAA

Check main circuit coolant level - AP20.30-P-2050CAA

WARNING: This page does not describe the selected car, but rather 203 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 177, 274, 276, 626, 651 in MODEL 205 

Shown on engine 651 

Fig 1: Locating Coolant Expansion Reservoir Cap (Engine 651)
G10037904Courtesy of MERCEDES-BENZ USA
DANGER Risk of injury  to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning  from swallowing coolant. Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.
AS20.00-Z-0001-01A
NOTES Notes on coolant   AH20.00-N-2080-01A
REMOVING Remove     
1 Unscrew cap (1) for coolant expansion reservoir (2)    
INSPECT Check     
2 Check coolant level IMPORTANT The coolant level on a cold engine must reach up to the marking (arrow) in the coolant expansion reservoir (2). When the coolant is warm, about 1 cm (0.39 inch) above the marking (arrow).
If coolant level is too low:
↓
Check coolant for leaktightness and check coolant for antifreeze content subject to separate repair order.
 
REFER TO CAPACITIES & SPECIFICATIONS Coolant specifications Coolant (Specification 310.1). See https://bevo.mercedes-benz.com/index.php?language_id=1
REFER TO CAPACITIES & SPECIFICATIONS Anticorrosion/antifreeze agents (Specifications 325.0) Anticorrosion/antifreeze agents (Specification 325.0). See https://bevo.mercedes-benz.com/index.php?language_id=1
FLUID SPECIFICATION Coolant mixing ratio *BF20.00-P-1001-04A 
INSTALLING Install     
3 Seal coolant expansion reservoir (2) with cap (1)    
COOLANT MIXING RATIO

Number Designation ENGINE ALL
BF20.00-P-1001-04A Coolant mixing ratio Antifreeze/water bis -37°C 50/50
Antifreeze/water bis -45°C 55/45
Specifications Coolant (Specification 310.1). See https://bevo.mercedes-benz.com/index.php?language_id=1