Remove/install electric parking brake actuator motor - AR42.20-P-0600W
MODEL 166, 172
Fig 1: Identifying Electric Parking Brake Actuator Motor Remove/Install Components - Shows Model 172.457
| Remove/install | |||
| Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit | ||
| 2 | Detach corresponding complete wheel | Model 166 | AP40.10-P-4050EW |
| Model 172 | AP40.10-P-4050V | ||
| 3 | Unhook electrical line (3) on retaining frame (1) | Model 172 | |
| 4 | Unclip retaining frames (1) on left electric parking brake actuator motor (M76/1) or right electric parking brake actuator motor (M76/2) | Model 172 | |
| 5 | Disconnect electrical connector (4) on left electric parking brake actuator motor (M76/1) or right electric parking brake actuator motor (M76/2) | ||
| 6 | Remove bolts (2) and remove left electric parking brake actuator motor (M76/1) or right electric parking brake actuator motor (M76/2) | ||
| *BA42.10-P-1006-12L | |||
| *BA42.10-P-1005-12J | |||
| 7 | Install in the reverse order | ||
| 8 | Carry out brake test on the test stand | AP42.00-P-4290BA |
REAR AXLE BRAKE CALIPER
| Number | Designation | Model 166 | |
|---|---|---|---|
| BA42.10-P-1006-12L | Bolt, actuator motor for parking brake to brake caliper | Nm | 12 |
REAR AXLE BRAKE CALIPER
| Number | Designation | Model 172 | |
|---|---|---|---|
| BA42.10-P-1005-12J | Bolt, actuator motor to brake caliper | Nm | 12 |