Remove/install accelerator pedal - AR30.12-P-1321GZ

MODEL 164, 166 

Shown on model 164 

Fig 1: Identifying Accelerator Pedal Remove/Install Components - Shown On Model 164

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit	KEYLESS-GO start/stop button only on vehicles with code (889) Keyless-Go.
2	Remove cover under the dashboard on the driver-side	Model 164	AR68.10-P-1500GZ
3	Unscrew nuts (1)
4	Remove accelerator pedal (2)	Pull out accelerator pedal (2) in the upper part slightly and then push upwards, in order to loosen the lug (3).
5	Disconnect electrical connector (4)
6	Install in the reverse order