Check warning and function indicator lamps in instrument cluster - AP54.30-P-5451SLA

WARNING: This page does not describe the selected car, but rather 203 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 171

Fig 1: Identifying Warning And Function Indicator Lamps (Model 171)

Courtesy of MERCEDES-BENZ USA

	Check
1	Switch off engine and switch on ignition	Engine hood, trunk lid, retractable hardtop and all doors closed.
2	Operate parking brake
3	Check warning lamps (4, 6, 7, 8, 10) and indicator lamps (5, 9) for proper operation	In the event of complaints: ↓ Determine and rectify cause, subject to separate repair order
4	Manually switch on low beams
5	Switch on high beam	The high beams indicator lamp (3) must light up and there must not be a lamp failure message in the top multifunction display (11). In the event of complaints: ↓ Determine and rectify cause, subject to separate repair order
6	Engage reverse gear and press service brake	No lamp failure message in the top multifunction display (11).
7	Switch off ignition and exterior lights
8	Switch on hazard warning flasher	The left and right turn signal indicator lamps (1, 2) light and flash at the same time. In the event of complaints: ↓ Determine and rectify cause, subject to separate repair order
9	Switch off hazard warning flasher