Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling fumes during soldering. - AS00.19-Z-0002-01A

Wear protective gloves, protective clothing and safety glasses. Ensure that the work area is adequately ventilated. Secure power supply cables. Avoid sources of fire in working area. 

MODEL ALL 

Potential risks 

Risk of injury 

• Contact with hot objects without suitable protective clothing causes severe burns to the skin and eyes.
• Melted, spraying and dripping solder can cause injuries to skin and eyes.
• Potentially life-threatening electric shocks may occur if power supply cables or high-voltage lines become scorched or cut by sharp objects.

Risk of poisoning 

• Caused by inhaling the vapors from soldering additives, in particular flux.

Fire hazard 

• Caused by ignition of combustible materials and objects located close to the soldering equipment.

Safety instructions/precautions 

• Wear suitable protective work clothing and protective gloves.
• Wear safety glasses.
• Protect power supply cables against heat and sharp edges.
• Create a safe work surface for putting down hot tools and objects.
• Do not use soldering tools in wet or damp environments.
• Avoid unintentional operation.
• Switch off equipment after use.
• Do not work on energized parts.
• Use available soldering fume extractors.
• Only perform soldering operations in well-ventilated rooms.
• Keep combustible objects away from the workplace.
• When working with soldering materials, do not eat, drink, smoke or sniff. Keep well away from food.

First-aid measures 

• Do not rub affected areas of the skin; rinse with plenty of lukewarm water and cover with sterile dressings.
• Move unconscious person into the fresh air immediately and provide artificial respiration, if necessary.
• In the case of severe injuries, consult a physician immediately.