Remove/install front door lining - AR72.10-P-1000GW

MODEL 463 as of model year 2013 /facelift 2012 

Fig 1: Front Door Lining Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Front Door Lining Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Remove screw (1) with countersunk washer on door lining (2)
2	Remove covers (3)		Fig 3
3	Remove bolts (4)
4	Unclip door lining (2) from mounting clips (arrows) on front door	Move mounting wedge directly to mounting clips (arrows). Otherwise the retaining tabs on the mounting clips (arrows) can tear out of the door lining (2). Check mounting clips (arrows), replace if necessary.
			Fig 3
5	Detach door lining (2) from front door and guide lock button (5) out of door lining (2)	Detach door lining (2) from front door until electrical connectors and Bowden cable on inside door opener (6) are accessible.
6	Unhook Bowden cable from inside door opener (6)
7	Disconnect electrical connectors
8	Remove door lining (2)
9	Check door foil on front door	Check door foil, replace if necessary. Otherwise moisture can penetrate into the passenger compartment.
10	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA