Pulling off rubber mount with grooved ball bearing - AR41.10-P-0100-07TX

MODEL 172, 204, 207, 212, 218, 219, 231 

Fig 1: Identifying Puller, Two-Arm (000 589 88 33 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Puller Arms (129 589 00 34 00)

Courtesy of MERCEDES-BENZ USA

1. Position two-armed puller with puller arms (see magnified section).
2. Pull rubber mount (7b) together with grooved ball bearing off linkage arm of the rear propeller shaft.
   Fig 3: Pulling Rubber Mount Together With Grooved Ball Bearing Off Linkage Arm

   Courtesy of MERCEDES-BENZ USA