Remove/install control and operating unit - AR83.40-P-6350EW
MODEL 212, 218
Front control and operating unit
Shown on model 212 with code (279) Electronic gear selector
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Buffer the basic data of the automatic air conditioning control and operating unit (N22/7) in STAR DIAGNOSIS | When replacing the automatic air conditioning control and operating unit (N22/7). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 2 | Move selector lever or gearshift lever to rearmost position | ||
| 3 | Switch off ignition | ||
| 4 | Unclip cover (1) from upper control panel control unit (N72/1) using extraction hook and remove | Fig 2 | |
| 5 | Cover up center console using a dry cloth (4) | ||
| 6 | Remove bolts (2) | ||
| 7 | Open lid (3) | ||
| 8 | Apply extraction hook at denoted areas (arrows), release AAC control and operating unit (N22/7) by pulling upwards and remove, until the electrical connectors (5) are accessible | Fig 2 | |
| 9 | Disconnect electrical connectors (5) | ||
| 10 | Install in the reverse order | ||
| 11 | Teach in and normalize the actuator motors | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A |