Install rear wheel well section - AR63.10-P-0662-03CW

MODEL 204, 166, 207.3/4, 212, 218 

Shown on model 204.0 

Fig 1: Outer Rear Wheel Well Section Rivet Holes Area

Courtesy of MERCEDES-BENZ USA

1. Install outer rear wheel well (2) section, fit and fix in place.
2. Drill rivet holes in outer rear wheel well section (2) with Ø 5 mm bit (area A).
3. Remove outer rear wheel well section (2).
4. Deburr rivet holes on outer rear wheel well section (2) on both sides.
5. Coat insides of riveted joints with zinc dust paint.
6. Install rubber window spacers from glazing repair kit as spacers on rear fender at uniform intervals (area B).
7. Apply sealant to rear fender (area B).
8. Install outer rear wheel well (2) section, fit and fix in place.
9. Rivet outer rear wheel well section (2) an outer rear wheel well (1) with Ø 4.8 X 8 steel/steel rivet (area A).
10. Remove shavings and drill chips.