Check battery - AR54.10-P-1129-01A

MODEL 117, 124, 126, 129, 140, 156, 163, 164, 166, 168, 169, 170, 171, 172, 176, 199, 201, 202, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 231, 240, 242, 245, 246, 251, 292, 451, 453, 461, 463 

MODEL 190 except CODE U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

MODEL 197 except CODE P98 (Black Series) 

MODEL 205 except CODE P25 (BlueEFFICIENCY Edition) except CODE U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

MODEL 213, 253 except CODE U98 (LITHIUM-ION STARTER BATTERY (LISB)) 

MODEL 217 (except 217.37/47) 

MODEL 222 (except 222.07) 

000 588 02 19 00 Battery tester

WS54.00-N-3006B

Whenever possible, perform the tests with the battery still installed and connected.

If, when testing, the battery tester shows a "Surface voltage detected" message, this indicates an increased voltage.

1. Switch off ignition.
2. Switch off lighting and audio components.
3. Connect battery tester to battery.

   Do not connect battery tester to jump start or charging terminal point; always connect it directly to the battery.

   Otherwise the test result may be incorrect.

   Once the battery tester has been connected the currently measured battery voltage is displayed.

   For system noise

   Wait for approx 2 minutes until the bus systems are switched off, and the no-load current is minimized.

4. Conduct test procedure to match the battery tester menu navigation.
5. After the test print out the test code displayed and store it safely in a tamperproof manner.