Retrofit Night View Assist control unit - AN54.30-P-0001-03EW

MODEL 212.0##/1##/2## 1# 

1. Connect black, 6-pin female connector (1) of power supply wiring harness (5) to Night View Assist control unit (N101).
2. Connect violet, 2-pin female connector (2) of power supply wiring harness (5) to Night View Assist control unit (N101).
   Fig 1: Power Supply Wiring Harness And Female Connectors

   Courtesy of MERCEDES-BENZ USA
3. Connect silver, 10-pin female connector (3) of low voltage differential signal (LVDS) line (4) to Night View Assist control unit (N101).

   The silver, 10-pin female connector (3) of the LVDS line (4) which is at the white length adjustment marking (arrow) must be used.

4. Position Night View Assist control unit (N101) on mounts at right A-pillar and screw down securely using sheet metal nuts (6).
   Fig 2: Night View Assist Control Unit And Sheet Metal Nuts

   Courtesy of MERCEDES-BENZ USA