Retrofit illuminated door sill molding - AZ82.20-P-0001ELB
MODEL 218.3 Installation of 4-fold door sill, AMG
| Remove | |||
| Risk of death caused by contact with parts conducting high voltages. | Do not come into contact with parts that are under high voltage. Persons who wear electronic implants (e.g. heart pacemakers) must not perform any work on such components. | AS00.00-Z-0020-01A | |
| Notes on avoiding damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Move back driver seat and front passenger seat | ||
| 2 | Disconnect battery ground line | AR54.10-P-0003EW | |
| 3 | Remove left and right front interior door sill | ||
| 4 | Detach edge guard on left and right in area of door sill and A-pillar paneling | ||
| 5 | Remove paneling from bottom of left and right A-pillar | ||
| 6 | Remove cover below right dashboard | ||
| 7 | Remove cover below left of instrument panel | ||
| 8 | Loosen floor covering on left and right-hand side of footwell and fold back | ||
| 9 | Detach front SAM control unit with fuse and relay module and place to one side | AR54.21-P-1260CW | |
| Install | |||
| 10 | Retrofit illuminated door sill moldings (1) | AZ82.20-P-0001-01ELB | |
| Cleaner | *BR00.45-Z-1025-04A | ||
| 11 | Retrofit wiring harness of illuminated door sill molding | AZ82.20-P-0001-04ELB | |
| Figure | |||
| 12 | Install remaining parts | ||
| 13 | Perform function check on illuminated door sill moldings (1) | ||
| 14 | Document retrofitted equipment via vehicle documentation (VeDoc) | Attach "Illuminated door sill moldings retrofitted as per AZ82.20-P-0001ELB " note under field organization texts to design group 68. |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| B6 602 10 97 | AMG illuminated door sill molding, 4-fold illuminated | 1 |