Windshield wipers, windshield washer system and headlamp cleaning system - function check - AP82.30-P-8252SX

MODEL 216 

MODEL 221 

Fig 1: Identifying Windshield

Courtesy of MERCEDES-BENZ USA

Fig 2: Locating Windshield Washer System Switch & HCS Switch

Courtesy of MERCEDES-BENZ USA

	Check
	Risk of fire and explosion  caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning  caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury  or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin.	Wear protective clothing and tight-fitting safety glasses. No fire, naked flames or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children.	AS82.35-Z-0001-01A
	Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.	Always remove ignition key when working on windshield wiper mechanism.	AS82.30-Z-0001-01A
1	Close engine hood
2	Close trunk lid, doors, sliding roof and side windows
3	Switch on ignition
4	Check function of spray nozzles for windshield washer system on windshield and the setting		AP82.35-P-8252-01SX
		The spray jet must hit the windshield in the marked area. Correct the adjustment if necessary.
		Adjusting tool For clogged up spray nozzle: ↓ Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice.	Fig 3
5	Check park position of wiper blades	The wiper blades must not come into contact with the A-pillar or cowl. Otherwise the body or wiper mechanism will be damaged. In the event of any deviation to the park position: ↓ Check and adjust wiper arms subject to separate repair order.
6	Check setting of wiper arms on windshield	The wiper blades must not come into contact with the A-pillar or cowl. The body or wiper mechanism will otherwise be damaged. Spray water over the windshield washer system on the windshield and switch on wiper at highest setting. If there are problems: ↓ Determine and rectify cause, subject to separate repair order.
7	Press HCS [SRA] switch (S1s1)	Vehicles with CODE 600 (Headlamp cleaning system) or xenon headlamps The spray jet must impact in the light source area on the headlamp lens. Correct setting if necessary.
		Adjusting tool For clogged up spray nozzle: ↓ Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice. For spray nozzles that cannot be adjusted and with a deviating spray pattern: ↓ Replace spray nozzle subject to separate repair order.	Fig 3
8	Switch off ignition
9	Correct the fluid level in the windshield washer system reservoir		AP82.35-P-8210SX
		Only for service with Plus package.

Fig 3: Identifying Adjusting Tool (110 589 02 63 00)

Courtesy of MERCEDES-BENZ USA