Remove and install sun sensor - AR83.40-P-6720SX
MODEL 216.3, 221.0/1
Illustrated on model 221
MODIFICATION NOTES
| 24.4.06 | Removing rear engine hood cover eliminated | Model 221 |
| Remove/install | |||
|---|---|---|---|
| 1 | Switch off ignition and withdraw transmitter key or Keyless Go start/stop button from the EIS [EZS] control unit | ||
| 2 | Remove clips (3) and lift sound deadening mat (2) at bottom | ||
| 3 | Remove expansion clips (7) | ||
| 4 | Unscrew nuts (6) from bottom engine hood cover (5) | ||
| 5 | Unclip lower engine hood cover (5) and put down in engine compartment with lines still attached | ||
| 6 | Disconnect electrical connector (8) from AAC sun sensor (4 in total) (B32/2) and unclip AAC sun sensor (4 in total) (B32/2) | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 7 | Install in the reverse order |