Set or inspect fog lamps - AP82.10-P-8260-04SX

The light-dark boundary of the light beam must run horizontal at the height of the separating line (1) in the headlamp aimer (01).

1. Correct the front fog lamp setting if necessary using a Phillips-head screwdriver.

   Model 221: The adjustment screw for height adjustment (H) is accessible after opening the flap (2) in the wheelhouse lining (3).

   Fig 1: Setting/Inspecting Fog Lamps

   Courtesy of MERCEDES-BENZ USA

   Model 216: The adjustment screw for height adjustment (H) is accessible after removing the covering (4). Using a screwdriver carefully press the catch hook (4a) for dismantling towards the fog lamp and at the same time lift up the covering (4) off the bumper. Then carefully detach the covering (4) forward in the area of the catch hook (4b).

   Fig 2: Setting/Inspecting Fog Lamps (Model 216)

   Courtesy of MERCEDES-BENZ USA