Remove/install side paneling in rear - AR68.30-P-4780SC
MODEL 216.3
| Remove/install | |||
| 1 | Loosen rear seat backrest until rear seat backrest can be pulled toward front in area of side paneling (1) so that upper nut (7) can be loosened. | AR91.12-P-1620SC | |
| 2 | Lower left and right rear side window | ||
| 3 | Loosen door sill molding in rear area. | Figure | |
| 4 | Remove cover (2) | ||
| 5 | Loosen edge guard (4). | ||
| 6 | Remove vapor barrier (5) | ||
| 7 | Pull paneling (6) toward front and remove. | ||
| 8 | Loosen upper nut (7), do not unscrew completely. | ||
| 9 | Unscrew lower nut (7). | ||
| 10 | Remove expansion clip (8). | ||
| 11 | Unclip side paneling (1) from bottom, raise, loosen from inner sealing rail and tilt toward inside. | ||
| 12 | Disconnect electrical connector from left rear power window switch (S21/3) or right rear power window switch (S21/4) | ||
| 13 | Remove side paneling (1) | ||
| 14.1 | Remove retaining clips (9) from rear of side paneling (1). | When replacing side paneling (1). | |
| 15 | Install in the reverse order |