Electrical function diagram for fully integrated transmission control input signals - PE27.19-U-2055-60FAA
TRANSMISSION 722.9 in MODEL 204.0
| Item | Designation | Coordinates |
|---|---|---|
| A8/1 | Transmitter key | 12B |
| N3/10 | ME-SFI [ME] control module | 11E |
| N10/1 | Front SAM control module with fuse and relay module | 19B |
| N15/5 | Electronic selector lever module control module | 11K |
| N30/4 | Electronic Stability Program control unit | 15A |
| N73 | Electronic ignition switch control unit | 11A |
| S16/12 | Automatic transmission transmission mode button | 8L |
| X11/4 | Diagnostic connector | 19G |
| Y3/8n1 | Turbine wheel rpm sensor | 6D |
| Y3/8n2 | Internal transmission speed rpm sensor | 5E |
| Y3/8n3 | Output shaft rpm sensor | 2G |
| Y3/8n4 | Fully integrated transmission control control unit | 5H |
| Y3/8s1 | Selection range sensor | 2J |
| CAN C | Drive train CAN | 11H |
| CAN D | Diagnostic CAN | 19F |
| CAN E | Chassis CAN | 13D |
| 1 | Selection range sensor, signal | 4J |
| 2 | Turbine wheel rpm sensor, signal | 7G |
| 3 | Internal transmission speed rpm sensor, signal | 6G |
| 4 | Output shaft rpm sensor, signal | 5H |
| 5 | Automatic transmission transmission mode button, status | 8H 10K |
| 6 | Electronic selector lever module control unit, status | 8H |
| 7 | Transmission control diagnosis, communication | 8H 11E 18C 20G |
| 8 | Electronic Stability Program control unit, request | 9H 12E 16C |
| 9 | Circuit 15, status | 9H 11C 12E |
| 10 | Steering wheel gearshift buttons, status | 10H |
| 11 | Engine control, request | 10H |
| 12 | Electronic ignition lock control unit FBS code, request | 10H 12C |