Remove/install oil dipstick guide tube - AR18.40-P-3510MR
ENGINE 274 in MODEL 172, 204, 207
| Remove/install | |||
| 1 | Drain off engine oil and catch using a suitable container | ||
| Engine 274.910 in model 172, 204 | AP18.00-P-0101CWF | ||
| Engine 274.920 in model 204.9, 207 | AP18.00-P-0101CWH | ||
| 2 | Drain off coolant | AR20.00-P-1142MR | |
| 3 | Detach steering coupling at the steering shaft | Engine 274 in model 204.0/2/3, 207 | AR46.10-P-8000CW |
| 4 | Remove starter | AR15.30-P-7100MR | |
| 5 | Remove upper engine cover | ||
| 6 | Remove oil dipstick (1) | ||
| 7 | Detach cable duct (2) for alternator/starter wiring harness on transmission housing and vacuum pump | ||
| 8 | Disconnect coolant hose from heater cooler on bulkhead | ||
| 9 | Remove screw/bolt (3) | *BA01.45-P-1004-01T | |
| 10 | Unclip vacuum hose (4) at guide tube (5) | ||
| 11 | Remove screw/bolt (6) | *BA01.45-P-1004-01T | |
| 12 | Remove guide tube (5) upwards | ||
The seal must be replaced; observe the work instructions: ↓ |
*BA01.45-P-1004-01T | ||
| Replace seal on guide tube (5). | AR18.40-P-0815-01MR | ||
| 13 | Install in the reverse order | ||
| Check | |||
| 14 | Check engine oil level | ||
| Engine 274.910 in model 172, 204 | AP18.00-P-0101CWF | ||
| Engine 274.920 in model 204.9, 207 | AP18.00-P-0101CWH | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 15 | Carry out an engine test run and check engine for leaktightness |
OIL PAN
| Number | Designation | Engine 274 | |
|---|---|---|---|
| BA01.45-P-1004-01T | Bolt, guide tube for oil dipstick to oil pan/shielding for high-pressure pump | Nm | 9 |