Remove/install evaporator - AR83.30-P-5540RK
MODEL 231
| Remove/install | |||
| 1 | Remove air conditioner housing (A32) | AR83.30-P-5200RK | |
| 2 | Remove expansion valve (2) from refrigerant lines (15) | Alternately screw in screws/bolts (4). Otherwise the expansion valve (2) may tilt during installation. |
|
| 3 | Remove screws/bolts (8) and remove fresh air/recirculated air housing (9) | ||
| 4 | Disconnect Electrical connection (13) | ||
| 5 | Remove plug (11) from air conditioning housing bottom section (6) | ||
| 6 | Remove electrical wiring harness (12) from air conditioner housing bottom section (6) | ||
| 7 | Disconnect electrical connectors (18, 20) | ||
| 8 | Remove screws/bolts (1) | ||
| 9 | Remove clamps (10) | ||
| 10 | Remove air distribution box (14) from air conditioner housing bottom section (6) and air conditioner housing top section (7) | ||
| 11 | Remove air conditioner housing top section (7) from air conditioner housing bottom section (6) | ||
| 12 | Guide seal (5) over coolant lines (3) | ||
| Lubricant, rubber assembly 1 l | *BR00.45-Z-1010-06A | ||
| 13 | Remove evaporator (17) from air conditioner housing bottom section (6) | ||
| 14 | Remove bracket (16) from refrigerant lines (15) | ||
| 15 | Remove seal (5) from refrigerant lines (15) | ||
| 16 | Install in the reverse order |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 l | A 000 989 03 67 |