Bleed brake system - AR42.10-P-0010RK
MODEL 231
MODIFICATION NOTES
| 31.8.12 | Venting screw on brake caliper | BA42.10-P-1005-10U |
| Remove | |||
|---|---|---|---|
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | AS42.50-Z-0001-01A | |
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| Brake fluid notes | AH42.50-P-0001-01A | ||
| 1 | Open engine hood | ||
| Clean | |||
| 2 | Clean area around cap (1) of brake fluid expansion reservoir (2) | ||
| Preparation for bleeding procedure | |||
| 3 | Unscrew cap (1) of brake fluid expansion reservoir (2) | ||
| 4 | Fill with new brake fluid up to the "MAX" mark in the brake fluid expansion reservoir (2) | *BF42.10-P-1001-01J | |
| 5 | Connect filler/bleeder unit (01) to brake fluid expansion reservoir (2) and switch on | ||
| 000 588 01 82 00 Filling unit | WS25.00-P-0016B | ||
| Remove | |||
| 6 | Remove front wheel-and-tire assemblies | ||
| AP40.10-P-4050EW | |||
| Bleeding | |||
| 7 | Carrying out bleeding operation | AR42.10-P-0010-02RK | |
| 000 588 01 82 00 Filling unit | WS25.00-P-0016B | ||
| *BA42.10-P-1005-10U | |||
| *BA42.10-P-1002-12J | |||
| 8 | Switch off filler/bleeder unit (01) and remove from brake fluid expansion reservoir (2) | ||
| 9 | Screw cap (1) onto brake fluid expansion reservoir (2) | ||
| Check | |||
| 10 | Check brake system for leaks | AR42.10-P-0100-01V | |
| 11 | Check fluid level in brake fluid expansion reservoir (2); correct if necessary | ||
| AP42.10-P-4210V | |||
| Install | |||
| 12 | Mount front wheel and tire assemblies | ||
| AP40.10-P-4050EW | |||
| 13 | Close engine hood |
REAR AXLE BRAKE CALIPER
| Number | Designation | Model 231 | |
|---|---|---|---|
| BA42.10-P-1002-12J | Bleed screw to brake caliper | Nm | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | Model 231.457/473 | MODEL 231.474 except CODEB07 | |
|---|---|---|---|---|
| BA42.10-P-1005-10U | Bleed screw on brake caliper | Nm | 18 | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 231.474 with CODE B07 | MODEL 231.479 except CODEB07 | |
|---|---|---|---|---|
| BA42.10-P-1005-10U | Bleed screw on brake caliper | Nm | 18 | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 231.479 with CODE B07 | |
|---|---|---|---|
| BA42.10-P-1005-10U | Bleed screw on brake caliper | Nm | 18 |
BRAKE FLUID
| Number | Designation | Model 231 | ||
|---|---|---|---|---|
| BF42.10-P-1001-01J | Brake fluid | Filling capacity | Liter | ≈0, 6 |
| Specification | DOT 4. See GENERAL BRAKE FLUID (https://bevo.mercedes-benz.com/index.php?language_id=1) | |||
| Specification | MB 331.0 brake fluid A 000 989 08 07 | |||