Remove/install rear bumper - AR88.20-P-2200RK

MODEL 231 

Shown on left side of vehicle 

Fig 1: Rear Bumper Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Rear Bumper Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Rear Bumper Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rear center section paneling (2)		AR68.30-P-4785RK
2	Unscrew nuts (4)
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
3	Lift vehicle on vehicle lift		AR00.60-P-1000TX
4	Remove bolts (5) on left and right
5	Remove screw/bolts (9)
6	Remove expansion clips (6) on fender liner (7) on left and right
7	Remove bolts (8) on left and right	For this purpose push fender liner (7) to side.
8	Disconnect electrical connector (10)
9	Unclip rear bumper (1) from rear fender in direction of arrow (A)	Mounting wedge	Figure
10	Unclip rear bumper (1) below taillamp in direction of arrow (B) and remove	Mounting wedge	Figure
11	Install in the reverse order

Fig 4: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA