LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2013 >> SL63 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Air Intake, Turbocharging - 231 Chassis >> Testing & Repair >> Remove/install low temperature water circuit radiator >> Remove/install low temperature water circuit radiator - AR09.41-P-6935RKB

Remove/install low temperature water circuit radiator - AR09.41-P-6935RKB

ENGINE 157, 278 in MODEL 231 

Fig 1: Low Temperature Water Circuit Radiator Remove/Install Components (1 Of 2)
G11128469Courtesy of MERCEDES-BENZ USA
Fig 2: Low Temperature Water Circuit Radiator Remove/Install Components (2 Of 2)
G11128470Courtesy of MERCEDES-BENZ USA
DANGER Risk of injury  to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning  from swallowing coolant. Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers.
Wear protective gloves, protective clothing and safety glasses.
AS20.00-Z-0001-01A
NOTES Notes on avoiding damage through contamination and foreign objects   AH00.00-P-5000-01A
NOTES Notes on coolant   AH20.00-N-2080-01A
REMOVINGINSTALLING Remove/install     
1 Drain air conditioning system   AR83.30-P-1760YF
2 Remove radiator (1) INSTALLATION IMPORTANT Only install lower engine compartment paneling after leak test. AR20.20-P-3865RK
3 Remove coolant lines (2, 3) from cooler for low-temperature water circuit (21)   AR20.20-P-7441-01RQ
4 Detach refrigerant lines (4, 5) for A/C on condenser (24)   AR83.30-P-6540RK
5 Release and disconnect electrical connection for refrigerant pressure sensor    
6 Detach transmission oil cooling lines (6) from oil cooler (23)   AR27.10-P-0501-03SX
    SPECIAL TOOL Record plug Figure
7 Detach engine oil cooler from lower air duct segment and secure with lines still connected outside the working area against falling down Engine 157 in model 231  
8 Remove radiator package downwards IMPORTANT The cooler for low-temperature water circuit (21), oil cooler (23) and the condenser for air conditioning (24) form one unit and can therefore only be removed together downwards.  
9 Unclip cooler for low-temperature water circuit (21) from radiator support (22) and remove    
10 Check cooler for low-temperature water circuit (21) for damage For damage
↓
Replace radiator for low-temperature water circuit (21).
 
11 Install in the reverse order    
12 Check and correct transmission oil level   AR27.00-P-0270W
DANGER Risk of accident  from vehicle starting off by itself when engine running. Risk of injury  (bruises and burns) resulting from working on the engine while it is being started or when it is running. Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. AS00.00-Z-0005-01A
13 Perform an engine test run and check the engine cooling system for leaktightness    
Fig 3: Identifying Record Plug (129 589 00 91 00)
G11065549Courtesy of MERCEDES-BENZ USA