Removing and installing keyless go antenna - AR82.62-P-8000RK

MODEL 231 with CODE 889 (Keyless Go) 

Fig 1: Keyless Go Antenna Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Keyless Go Antenna Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Keyless Go Antenna Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73)	KEYLESS-GO start/stop button only present on vehicles with CODE 889 (Keyless-Go).
2.1	Remove upper control panel cover (1)	When removing interior KEYLESS-GO antenna (A2/61). Remove/install COMAND controller unit Only perform operation steps required for removal of upper control panel cover (1).	AR82.85-P-1100RK
2.2	Remove door lining at driver door	When removing left door KEYLESS-GO antenna (A2/38) or right door KEYLESS-GO antenna (A2/40).	AR72.10-P-1000RK
2.3	Remove soundproofing (6)	When removing trunk KEYLESS-GO antenna (A2/35). Remove/install hydraulic unit Only perform operation steps required to remove soundproofing (6).	AR77.37-P-3500RK
3.1	Unhook left door KEYLESS-GO antenna (A2/38) or right door KEYLESS-GO antenna (A2/40), (A2/61) from bracket (4)	When removing left door KEYLESS-GO antenna (A2/38) or right door KEYLESS-GO antenna (A2/40).
3.2	Unhook interior KEYLESS-GO antenna (A2/61) from bracket (3)	When removing interior KEYLESS-GO antenna (A2/61).
3.3	Remove trunk KEYLESS-GO antenna (A2/35)	When removing trunk KEYLESS-GO antenna (A2/35). To do this, unscrew nuts (5).
4	Disconnect corresponding electrical connector (2a, 2b, 2c)
5	Install in the reverse order