Remove/install power window motor in rear door - AR72.29-P-1880SX
MODEL 221.0
MODEL 221.1 except CODE (Z07) Top protection
Shown on model 221.0
| Remove/install | |||
| 1 | Remove door lining from left or right rear door | AR72.12-P-1010SX | |
| 2 | Disconnect electrical connector (1) | ||
| 3 | Remove bolts (2) | *BA72.12-P-1010-01M | |
| 4 | Loosen left rear power window motor (M10/5) or right rear power window motor (M10/6) and remove | Figure | |
| 5 | Install in the reverse order | ||
| 6 | Normalize power window motor |
REAR DOOR
| Number | Designation | Model 221 | |
|---|---|---|---|
| BA72.12-P-1010-01M | Bolt, power window motor to door module | Nm | 3 |