Remove/install crank window in rear door - AR72.12-P-1910SX

MODEL 221.0

MODEL 221.1 except CODE (Z07) Top protection

Fig 1: Identifying Rear Door Crank Window Remove/Install Component - Shown On Model 221.0

Courtesy of MERCEDES-BENZ USA

Shown on model 221.0 without code (297) Roller sun blind in rear doors

Fig 2: Identifying Rear Door Crank Window Remove/Install Component - Shown On Model 221.0

Courtesy of MERCEDES-BENZ USA

Shown on model 221.1 with code (297) Roller sun blinds in rear doors

	Remove/install
	Risk of injury due to hands being crushed when window glass is not secure	Secure window to prevent it from falling down.	AS67.00-Z-0002-01A
1	Remove door lining from rear door		AR72.12-P-1010SX
2.1	Remove cover strip (8) upward with pulling hook	On vehicles with code (297) Roller sun blinds in rear doors
2.1	Remove cover strip (8) upward with pulling hook		Fig 4
3	Remove inner sealing rail (2)		Figure
4	Remove outer sealing rail (4)		Figure
5	Pull window guide seal (9) out of window separator bar (3).	Use liquid lubricant. Position window guide seal (9) in window separator bar (3) and window frame with end shaft of roller.
			Figure
		Antifriction agent	*BR00.45-Z-1010-06A
6	Unscrew bolt (11).
7	Unscrew bolt (10) and remove window separator bar (3).	Coat window separator bar (3) in bottom area with lubricant and install.
			*BA72.12-P-1013-01M
		Antifriction agent	*BR00.45-Z-1010-06A
8	Take out cover (5)
9	Connect power window switch of door lining removed to left rear door control unit (N69/3) or right rear door control unit (N69/4). Switch on ignition and move crank window (1) until bolt (6) is accessible.	After moving up crank window (1) switch off ignition and disconnect power window switch.
10	Unscrew bolt (6).	Completely slide crank window (1) toward rear and tighten with bolt (6).
10	Unscrew bolt (6).		*BA72.12-P-1011-01M
11	Remove crank window (1) from rear door window channel upward
12	Install in the reverse order