Remove/install steering wheel - AR46.10-P-0100I

MODEL 215, 220 (except 215.374/379, 220.074/174/179) 

MODEL 230 (except 230.479) up to 28.1.08 

MODEL 230 as of 29.1.08 

MODEL 230 with CODE (809) Model year 2009 

Fig 1: Identifying Countersunk Screw

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Steering Wheel

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Fanfare Horns And Airbag Clock Spring Contact

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove airbag unit from steering wheel (32)	Model 215, 220
		Model 230.4 up to 28.1.08 except code (809) Model year 2009.	AR91.60-P-0660R
		Model 230.4 as of 29.1.08 or code (809) Model year 2009.	AR91.60-P-0660RA
2	Move steering wheel (32) to horizontal position	Front wheels in straight-ahead position.
3	Remove countersunk screw (32c), steadying steering wheel (32).	Replace countersunk bolt (32c).
			*BA46.10-P-1001-02A
4	Remove steering wheel (32)	Do not pay attention to the markings on the upper steering shaft. The front wheels must be in the straight-ahead position. Fit steering wheel (32) horizontally onto steering shaft. The recesses in the splines (arrows) run vertically.
5	Check fanfare horns and airbag clock spring contact (A45) for damage	When the steering wheel (32) is detached, the fanfare horns and airbag clock spring contact (A45) must not be twisted, otherwise it will be damaged. Replace damaged fanfare horns and airbag clock spring contact (A45), see: ↓
		Remove/install clock spring contact	AR46.10-P-0200I
6	Install in the reverse order
7	Conduct a road test	Tests during the road test: Turn signal reset  When the steering wheel is offset by more than 1 tooth, satisfactory resetting of the turn signal is no longer guaranteed. Airbag indicator lamp  The SRS indicator lamp must not light up on full steering lock in both directions. Steering wheel position (32)  If the steering wheel (32) is crooked, adjust it by max. 1 tooth.