Remove/install backup camera control unit - AR54.65-P-0025SX
MODEL 216.3 up to 5/31/07, 221.0 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version)
MODEL 216.3, 221.0 with CODE 218 (Rear view camera) with CODE 498 (Japanese version)
MODEL 221.1 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version)
MODEL 221.1 with CODE 218 (Rear view camera) with CODE 498 (Japanese version)
Shown on model 221
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1.1 | Switch off ignition and remove transmitter key from electronic ignition lock control unit | Vehicles except CODE 889 (KEYLESS-GO) | |
| 1.2 | Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit | Vehicles with CODE 889 (KEYLESS-GO) | |
| 2 | Release the left trim in the side of the luggage compartment (1) and swivel to one side until the backup camera control unit (N66/2) is accessible | MODEL 216.3 up to 5/31/07, 221.0 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version) MODEL 216.3, 221.0 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) MODEL 221.1 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version) without CODE Z07 (Top protection) MODEL 221.1 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) without CODE Z07 (Top protection) |
AR68.30-P-4600SX |
| MODEL 221.1 up to 5/31/07 with CODE 218 (Rear view camera) with CODE Z07 (Top protection) without CODE 498 (Japanese version) MODEL 221.1 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) with CODE Z07 (Top protection) Do not bend hinge lever passage frame (2). Otherwise the plastic will be discolored. |
AR68.30-P-4600SXS | ||
| 3 | Unscrew nuts (7) from bracket (4) | ||
| 4 | Release nuts (5) and bolt (6) far enough until the bracket (4) can be removed | ||
| 5 | Remove bracket (4) and place to one side with connected lines | ||
| 6 | Remove reversing camera control unit (N66/2) from bracket (4) | ||
| 7 | Disconnect electrical connectors (8) | ||
| 8 | Remove backup camera control unit (N66/2) | ||
| 9 | Install in the reverse order | ||
| 10 | Calibrate backup camera When replacing the backup camera control unit (N66/2). | ||
| MODEL 216.3, 221.0 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) MODEL 221.1 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) |
AR54.65-P-0022GZ | ||
| MODEL 216.3 up to 5/31/07, 221.0/1 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version) |
AR54.65-P-0022SX |