Remove/install trim strip on rear door window frame - AR72.12-P-1710SX

MODEL 221.0 

MODEL 221.1 except CODE (Z07) Top protection 

Fig 1: Identifying Rear Door Window Frame Trim Strip Remove/Install Components

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

23.9.05

Riveter changed

Operation step 7

	Remove/install
1	Completely open crank window in left or right rear door
2	Loosen sealing (1) from trim strip (7).		AR72.12-P-1550SX
3	Pull door frame seal (2) downward in areas of rivets (6) and fasten with strips of adhesive tape (3)	Do not pull door frame seal (2) downward too forcefully, otherwise the glued door frame seal (2) can detach from the window frame (5). This prevents damaging the door frame seal (2) when drilling out the rivets (6) later.
4	Mask gap between door frame seal (2) and window frame (5) over entire length with strips of adhesive tape (4)	This ensures that no chips or drilling residues fall into the gap.
5	Plug opening (arrow) in front area of window frame (5).	This ensures that no chips or drilling residues fall into the window frame (5).
6	Cover door lining to protect against chips falling down.
7	Drill out rivet heads on rivets (6) with Ø 3.5 mm bit.	Do not drill through rivets (6) to prevent damaging the window frame (5) Pliers
8	Unscrew bolt (8) from window separator bar (9) at top
9	Completely remove rivet residues.	Remaining rivet residues cause corrosion damage.
10	Loosen trim strip (7) from window frame (5) and remove	Repair paint damage on window frame (5) before assembly.
			Figure
11	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA