Remove/install power window hydraulic pump - AR72.29-P-0300SXS
MODEL 221.1 with CODE (Z07) Top protection with hydraulic power windows
| Remove/install | |||
| 1 | Switch off the ignition and remove the transmitter key from the EIS control unit | ||
| 2 | Relieve pressure in pressure reservoir of hydraulic power window | Power window in front door | AR72.10-P-1800-06SXS |
| Power window in rear door | AR72.12-P-1810-06SXS | ||
| 3 | Remove spare tire in trunk | ||
| 4 | Remove cover (2) of power window hydraulic pump (Y71/1) | ||
| 5 | Expose and disconnect all hydraulic lines (3) on power window hydraulic pump (Y71/1) | ||
| 6 | Separate power supply hydraulic unit power supply connector (X201) and power window control lines connector (X202) | ||
| 7 | Remove nuts (5) and remove power window hydraulic pump (Y71/1) from trunk together with carrier plate (6) | ||
| 8 | Install in the reverse order | ||
| 9 | Check fill level of power window hydraulic pump(Y71/1); correct if necessary | ||
| Power window system - check oil level | AP67.30-P-6710SX |