Legend of wiring diagram for two-way radio - PE82.71-P-2000-60SAA
Model 221.0/1 with CODE (450) Taxi-version control unit N26/9
| Code | Designation | Coordinates |
|---|---|---|
| A0 | Color code key | 40L |
| A2/5 | Antenna splitter | 16L |
| A2/22 | Telephone 1 antenna | 2L |
| A2/49a2 | GPS antenna | 18L |
| A2/49a3 | Two-way radio antenna | 20L |
| A49 | Two-way radio | 6L |
| A49/5 | Radio data transmission keyboard | 22L |
| A49/5 | Radio data transmission keyboard | 30L |
| B25/1 | Microphone | 11L |
| H6 | Taxi two-way radio speaker | 13L |
| N26/9 | Special vehicle multifunction control module (SVMCM) | 4A |
| N26/9 | Special vehicle multifunction control module (SVMCM) | 12A |
| N26/9 | Special vehicle multifunction control module (SVMCM) | 20A |
| N26/9 | Special vehicle multifunction control module (SVMCM) | 28A |
| N26/9 | Special vehicle multifunction control module (SVMCM) | 33A |
| U900 | Further line routing not clarified at time of publication | 4E |
| W19 | Ground (right front seat crossmember) | 10G |
| W19 | Ground (right front seat crossmember) | 25G |
| X1/44 | Taxi peripherals separation point | 35L |
| X1/45 | Two-way radio speaker separation point | 4G |
| X1/45 | Two-way radio speaker separation point | 13G |
| X35/1 | Left front door and FFS [RBA] connector | 13K |
| X39/35 | GPS antenna connector | 14L |
| X39/63 | Taxi two-way radio antenna separation point | 1H |
| X39/63 | Taxi two-way radio antenna separation point | 19G |
| Z7/69 | Two-way radio circuit 30 connector sleeve | 7E |
| Z12 | Connector sleeve 4 (solder connector in wiring harness) | 27E |
| Z13 | Connector sleeve 5 | 36G |
| Z14 | Connector sleeve 6 (solder joint in harness) | 28E |
| Z19/1 | Connector sleeve 12 | 9F |
| Z20/30 | Tracer wire connector sleeve | 8E |
| Z20/31 | Tracer wire connector sleeve | 34K |
| Z20/33 | Tracer wire connector sleeve | 28H |
| Z20/34 | Tracer wire connector sleeve | 34K |
| Z20/73 | Tracer wire connector sleeve | 28F |
| Z37/6 | CAN databus (high) connector sleeve | 30G |
| Z37/7 | CAN bus (low) connector sleeve | 29F |