Remove/install front axle level sensors - AR82.10-P-0004I
MODEL 215
MODEL 220
Shown on model 220 AIRmatic
| Remove/Install | |||
| Replace self-locking nuts and bolts | |||
| 1.1 | Remove front wheels | Vehicles with AIRmatic (Code 489a) | |
| 2 | Disconnect connectors at front left and right level sensors (B22/8, B22/9) | ||
| 3 | Unscrew nut (86c) on connecting rod (86) from front left and right level sensors (B22/8, B22/9) | *BA82.10-P-1002-01A | |
| 4.1 | Unscrew nut (86b) on connecting rod (86) from upper wishbone (6) and remove connecting rod (86) | Vehicles with AIRmatic (Code 489a) |
|
| *BA82.10-P-1001-01A | |||
| 5 | Unscrew bolts (86d) on retaining plate (86a) and remove front left and right level sensors (B22/8, B22/9) | *BA82.10-P-1003-01A | |
| 6 | Install in the reverse order | ||
| 7 | After replacing the level sensors, calibrate vehicle level with Star Diagnosis (level calibration) |
FRONT AXLE LEVEL SENSOR
| Number | Designation | Model 215 | Model 220 | |
|---|---|---|---|---|
| BA82.10-P-1001-01A | Nut, level sensor connecting rod to upper wishbone | Nm | 10 | 10 |
| BA82.10-P-1002-01A | Nut, connecting rod to level sensor | Nm | 5 | 5 |
| BA82.10-P-1003-01A | Bolt/nut of level sensor to retaining plate | Nm | 4 | 4 |