LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2013 >> S400 >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Electrical System - Engine - General Information) >> General Information >> Notes on avoiding damage to ignition system >> Notes on avoiding damage to ignition system - AH15.10-P-0002-01L

Notes on avoiding damage to ignition system - AH15.10-P-0002-01L

WARNING: This page does not describe the selected car, but rather 199 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 137, 275, 279, 285 

NOTES

Energy Controlled Ignition (ECI) ignition system 

It is not possible to test the ignition sparks for example during a roadside assistance on this ignition system.

It is only possible to determine faults in this ignition system through reading out the diagnostic trouble code memory using the diagnostic system.

The electrical connections for ignition system components can only be disconnected after switching off the ignition.

To avoid damage, the ignition must not be switched on without a ground supply on the power pack for the ECI ignition system (N91). A sufficient ground supply can only be assured, if the power pack for the ECI ignition system (N91) is bolted on to the intake manifold (1).

Shown on engine 137 

Fig 1: Identifying Intake Manifold And ECI Ignition System Power Pack
G10037437Courtesy of MERCEDES-BENZ USA