Interference fit of crankshaft bearing cap - AH03.20-P-4351-02TK
WARNING: This page does not describe the selected car, but rather 199 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 271
The crankshaft bearing caps are machined together with the crankcase and must not be swapped.
The crankshaft bearing caps are fitted into the side of the crankcase. The fit is offset by 0.5 mm from the center, meaning that the crankshaft bearing caps can be installed in one position only. If installed correctly, the lug (arrow) on the crankshaft bearing cap points to the right when looking in the direction of travel.
Courtesy of MERCEDES-BENZ USA
The crankshaft bearing caps (6, 6a) are numbered consecutively starting with the first crankshaft bearing cap at the front.
Courtesy of MERCEDES-BENZ USA