Interference fit of crankshaft bearing cap - AH03.20-P-4351-02SX
WARNING: This page does not describe the selected car, but rather 199 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 273
The crankshaft bearing caps are machined together with the crankcase and must not be interchanged.
- The crankshaft bearing caps are fitted on the side in the crankcase and must be mounted in the correct installation position. If the installation position is correct, the semicircle will point (3) in the direction of travel (arrow).
- The crankshaft bearing caps are numbered consecutively on the semicircles (3) beginning with the first crankshaft bearing cap at the front.