Remove/install rear door lock - AR72.12-P-2510SX

MODEL 221.0 

MODEL 221.1 except CODE (Z07) Top protection 

Fig 1: Identifying Rear Door Lock Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove door module (4)		AR72.12-P-0103SX
2	Remove electric wiring harness (2) from door lock (1).
3	Remove lock button (3).	Mark installation position.
4	Unclip door lock (1) from door lock bracket (5)
5.1	Unclip bearing bracket (7) from door lock (1)	When replacing door lock (1)
6.1	Remove cover (9)	When replacing door lock (1)
7.1	Remove Bowden cables (10, 11) from locking bar (14) on door lock (1)	When replacing door lock (1)
	Install
8.1	Hook locking bar (14) into door lock (1)	When replacing door lock (1) Hook locking bar (14) into lower hole in safety lever on door lock (1).
9.1	Hook Bowden cables (10, 11) into door lock (1)	When replacing door lock (1)
10.1	Install bearing bracket (7) on door lock (1)	When replacing door lock (1)
11.1	Clip door handle (6) into bearing bracket (7).	When replacing door lock (1)
12.1	Install door handle guide (15) in bearing bracket (7).	When replacing door lock (1)
13.1	Adjust clearance (A) on adjusting screw (8)	When replacing door lock (1) Lift ant-twist lock on bearing bracket (7) to turn adjusting screw (8).	*BE72.12-P-1001-01D
14.1	Install new cover (9)	When replacing door lock (1)
15.1	Remove door handle (6) from bearing bracket (7).	When replacing door lock (1)
16.1	Remove door handle guide (15) from bearing bracket (7).	When replacing door lock (1)
17	Install door lock (1) on door lock bracket (5).	Ensure that grommets (12, 13) are seated correctly in door module (4).
18	Install lock button (3).
19	Attach wiring harness (2)
20	Install door module (4)		AR72.12-P-0103SX