Remove/install stabilizer bar on rear axle - AR32.20-P-0315SXS

MODEL 221.1 with CODE (Z07) Top protection

Fig 1: Identifying Rear Axle Stabilizer Bar Remove/Install Components

G10127134

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	While working on the rear axle, care must be taken to ensure that the surface of aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected
	Only tighten nuts and bolts of chassis components when vehicle is in a ready-to-drive condition.
1	Lower rear axle.		AR35.10-P-0015SX
2	Detach clamp connection (4) of link rod (4a) of level sensor (B22/3) from stabilizer bar (10)		*BA82.10-P-1005-02E
3	Remove nuts (23c) and push link rods (23) out of stabilizer bar (10)	Check rubber boots of link rods (23) for signs of damage; fit new link rods (23) if necessary.
3			*BA32.20-P-1002-04G
4	Remove bolts (21e) and remove stabilizer bar (10)	Check rubber mount (10a) of stabilizer bar (10) for damage and wear, replace stabilizer bar (10) if necessary. The rubber mounts (10a) are molded onto the stabilizer bar (10).	*BA32.20-P-1003-04G
5	Install in the reverse order

REAR AXLE LEVEL SENSOR

Number	Designation		Model 221 without code 487
BA82.10-P-1005-02E	Nut of retaining shell of torsion bar intermediate lever to torsion bar	Nm	5

REAR AXLE STABILIZER BAR

Number	Designation		Model 221
BA32.20-P-1002-04G	Nut, link rod to stabilizer bar	Nm	50
BA32.20-P-1003-04G	Bolt, torsion bar to rear axle carrier	Nm	70