Remove/install rear door - AR72.12-P-0600SX

MODEL 221.0 

MODEL 221.1 except CODE (Z07) Top protection 

Shown on model 221.0 

Fig 1: Identifying Rear Door Remove/Install Components - Shown On Model 221.0

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Open front door
2	Completely move crank window in rear door (1) downward
3	Switch off ignition and withdraw transmitter key or Keyless Go start/stop button from the EZS control unit	Keyless Go start/stop button only for vehicles with code (889) Keyless Go.
4	Disconnect battery ground line		AR54.10-P-0003SX
5	Disconnect left rear door separation point (X35/3) or right rear door separation point (X35/4)
6	Unclip door holder (4) from B-pillar bracket with suitable screwdriver.	Carefully unclip door holder (4); if necessary, use rag to protect against paint damage.
7	Remove caps (2) from bolts (3)
8	Remove screws/bolts (3)		*BA72.12-P-1003-01M
9	Open front door (1), remove from door hinges with aid of helper and lay down on suitable subsurface	Remove rear door (1) carefully. Danger of damaging paint.
10	Install in the reverse order
11	Check adjustment of rear door (1), correct if necessary.		AR72.12-P-0650SX