Press grooved ball bearing out of rubber mount of propeller shaft, press in - AR41.10-P-0100-02TX

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 172, 204, 207, 212, 218, 219, 231

Fig 1: Identifying Removal And Installation Tool (116 589 09 43 00)

Courtesy of MERCEDES-BENZ USA

Press out

Press out grooved ball bearing (8) from rubber mount (7b) using press out/in tool (04a, 04b).

Fig 2: Pressing Out Grooved Ball Bearing From Rubber Mount
Courtesy of MERCEDES-BENZ USA

Press in

Press in grooved ball bearing (8) into rubberized bearing seat as far as the contact surface (arrows) using press out/in tool (04a, 04b).
Ensure that the grooved ball bearing (8) is properly seated.

Fig 3: Pressing Grooved Ball Bearing
Courtesy of MERCEDES-BENZ USA