LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2013 >> GL63 >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Lubrication, Engine Oil Cooling - Maintenance) >> Maintenance >> Check engine oil level with special tool >> Check engine oil level with special tool - AP18.00-P-1810OMG

Check engine oil level with special tool - AP18.00-P-1810OMG

WARNING: This page does not describe the selected car, but rather 199 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 648 

Fig 1: Checking Engine Oil Level (Engine 648)
G10037895Courtesy of MERCEDES-BENZ USA
DANGER Risk of accident  from vehicle starting off by itself when engine running. Risk of injury  bruises and burns) resulting from working on the engine while it is being started or when it is running. Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. AS00.00-Z-0005-01A
DANGER Risk of injury  to skin and eyes due to handling of engine oil. Risk of poisoning  caused by swallowing engine oil Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.		 AS18.00-Z-0001-01A
1 Allow engine to warm up IMPORTANT Coolant temperature min. 80 °C.  
2 Turn off engine    
3 Pull stop plug (4) out of oil measuring pipe (5) IMPORTANT The stop plug (4) and oil measuring pipe (5) can be at the front or rear of the engine (depending on the model series).  
INSPECT Check     
4 Guide dipstick (04) into oil measuring pipe (5) IMPORTANT The tip of SPECIAL TOOL dipstick (04) must be in the oil pan.
The collar of the handle sits close to oil measuring pipe (5).		  
SPECIAL TOOL Measuring rod *120589072100
5 Read off engine oil level at dipstick (04) SPECIAL TOOL Measuring rod *120589072100
6 Determine level using oil level table FLUID SPECIFICATION
ENGINE 648 in MODEL 211		 *BF18.00-P-1001-03S 
FLUID SPECIFICATION
ENGINE 648 in MODEL 220		 *BF18.00-P-1001-03Q 
  If the engine oil level is too high or too low, correct it     
7 Correct the engine oil level not for USA
Maintenance intervals in combination with oils as per MBBV sheet, general overview		 AP18.00-P-1849UD
Maintenance intervals in combination with oils as per MBBV sheet, general overviewFor USA only
IMPORTANT Check engine oil level again after correcting it. To do so repeat steps 4 through 6.
If engine oil level is too high,
↓
Suction off engine oil quantity according to the oil level table.
If engine oil level is too low,
↓
Fill engine oil quantity according to the oil level table.		 AP18.00-P-1849UDU 
8 Insert stop plug (4) into oil measuring pipe (5)    
OIL LEVEL CHECK

Number Designation ENGINE 648 in MODEL 220
BF18.00-P-1001-03Q Oil level Maximum mm 145
Minimum mm 123
OIL LEVEL CHECK

Number Designation Engine 648 in model 211
BF18.00-P-1001-03S Oil level Maximum mm 134
minimum mm 114
Fig 2: Identifying Measuring Rod (120 589 07 21 00)
G10037896Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals