Remove/install rebound - AR77.20-P-1400GW

MODEL 463 (except 463.202) as of model year 2013/model refinement package 2012

Fig 1: Rebound Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove paneling from tilting/sliding roof		AR77.20-P-0500GW
2	Remove bolt (1)
3	Open guide plate (2) (see arrows) and pull out of guide on operating cable (4)
4	Actuate switch to open	Allow operating cable (4) to run out of gear. If the operating cable (4) cannot be moved with the electric drive, use emergency crank, see: ↓
4	Actuate switch to open	Remove left rear pillar panel Operating emergency crank: Completely pull out emergency crank and then press in approx. 3 to 4 mm.	AR68.30-P-4505GW
5	Pull control cable (4) out toward front	If the control cable (4) cannot be pulled out: Disassemble gear of electric drive. If the operating cable (4) cannot be pulled out after disassembling electric drive: ↓
5	Pull control cable (4) out toward front	Remove guide tube (3) for tilting/sliding roof cable.	AR77.20-P-1410GW
	Install
6	Install guide tube (3) of operating cable (4)	It guide tube (3) is removed	AR77.20-P-1410GW
7	Assembly gear for electric drive	Only if electric drive has been disassembled when removing gear
8	Coat end of new operating cable (4) with lubricant	Synthetic grease for sliding roof	*BR00.45-Z-1004-06A
9	Completely insert operating cable (4) into guide tube (3)
10	Install guide plate (2) on operating cable (4) and press together
11	Completely insert operating cable (4) into guide tube (3)
12	Set SR switch to "Lower roof"	Allow operating cable (4) to run into gear until holes in guide plate (2) and sliding carrier coincide with one another.
13	Tighten guide plate (2) on sliding carrier
14	Close tilting/sliding roof
	Adjust
15	Perform basic adjustment for operating cable (4) on roof system motor (M12m1) and whether tilting/sliding roof closes properly		AR77.20-P-1100-05A
	Centering bolts for sliding roof		WF58.50-P-7720-01A
		If the tilting/sliding roof does not close exactly after this adjustment, see: ↓
		Perform fine adjustment of tilting/sliding roof.	AR77.20-P-1100-02A
16	Carry out function check
	Install
17	Install paneling on rear pillar	If paneling is removed.	AR68.30-P-4505GW
18	Install paneling on tilting/sliding roof		AR77.20-P-0500GW

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1004-06A	Synthetic grease, sliding roof 500 g, DB supply specification 6827.60	A 001 989 46 51