Adjust tilting/sliding roof panel - AR77.20-P-1100GW

MODEL 463 (except 463.202) as of model year 2013/model refinement package 2012 

Fig 1: Adjustment Marks On Tilting/Sliding Roof Panel

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove paneling from tilting/sliding roof		AR77.20-P-0500GW
2	Close tilting/sliding roof
	Adjust
3	Adjust sliding jaws on tilting/sliding roof		AR77.20-P-1100-01A
4	Close tilting/sliding roof
5	Check adjustment markings (1, 2) on left and right slide angle for coincidence	If the adjustment mark (1) is not between the adjustment marks (2), see: ↓
		Perform fine adjustment of tilting/sliding roof.	AR77.20-P-1100-02A
6	Check dimension between outer skin of the roof and front tilting/sliding roof panel	if test value deviates: ↓	*BE77.20-P-1001-01B
		Adjust height at front of tilting/sliding roof.	AR77.20-P-1100-03A
7	Close tilting/sliding roof
8	Check dimension between outer skin of the roof and rear tilting/sliding roof panel	if test value deviates: ↓	*BE77.20-P-1001-01B
		Adjust height at rear of tilting/sliding roof.	AR77.20-P-1100-04A
	Centering bolts for sliding roof		WF58.50-P-7720-01A
	Install
9	Install paneling on tilting/sliding roof		AR77.20-P-0500GW
10	Install left rear pillar panel	If paneling is removed.	AR68.30-P-4505GW