LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2013 >> CLS550 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Electrical System - Body - Maintenance) >> Electrical System - Body - Maintenance >> Windshield wipers, windshield washer system and headlamp cleaning system - function check >> Windshield wipers, windshield washer system and headlamp cleaning system - function check - AP82.30-P-8252A

Windshield wipers, windshield washer system and headlamp cleaning system - function check - AP82.30-P-8252A

WARNING: This page does not describe the selected car, but rather 203 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 203, 209, 211 

Shown on model 203.0 

Fig 1: Identifying Windshield - Shown On Model 203.0
G10038216Courtesy of MERCEDES-BENZ USA

Shown on model 203.2 

Fig 2: Identifying Windshield - Shown On Model 203.2
G10038217Courtesy of MERCEDES-BENZ USA
Fig 3: Identifying HCS (SRA) Switch
G10038218Courtesy of MERCEDES-BENZ USA
INSPECT Check     
DANGER Risk of fire and explosion  caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning  caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury  or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin. Wear protective clothing and tight-fitting safety glasses. No fire, naked flames or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children. AS82.35-Z-0001-01A
DANGER Risk of injury  . Moving parts can pinch, crush or, in extreme cases even sever extremities. No parts of the body or limbs should be within the operating area of the mechanism when the components are moving. AS00.00-Z-0009-01A
1 Close engine hood    
REFER TO TESTING & REPAIR   MODEL 203 AR88.40-P-1000P
REFER TO TESTING & REPAIR   MODEL 209 AR88.40-P-1000Q
REFER TO TESTING & REPAIR   MODEL 211 AR88.40-P-1000T
2 Close liftgate or trunk lid, doors, sliding roof and side windows    
3 Switch on ignition    
4 Check function of spray nozzles for windshield washer system on windshield and the setting TYP 203, 209 AP82.35-P-8252-01P
MODEL 211
IMPORTANT The spray jet must hit the windshield in the marked area. Correct the adjustment if necessary.
AP82.35-P-8252-01T
SPECIAL TOOL Adjusting tool
For clogged up spray nozzle:

Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice.
Fig 4
5 Check function of spray nozzles for windshield washer system on rear window and the setting TYP 203.2/7, 211.2/6  
MODEL 203, 209 AP82.35-P-8252-01P
MODEL 211
For spray nozzles that cannot be adjusted and with a deviating spray pattern:

Replace spray nozzle subject to separate repair order.
For clogged up spray nozzle:

Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice.
AP82.35-P-8252-01T
6 Check park position of wiper blades NOTES
The wiper blades must not come into contact with the A-pillar, cowl or liftgate.
Otherwise the body or wiper mechanism will be damaged.
In the event of any deviation to the park position:

Check and adjust wiper arms subject to separate repair order.
 
7 Check setting of wiper arms on windshield NOTES
The wiper blades must not come into contact with the A-pillar or cowl.
The body or wiper mechanism will otherwise be damaged.
IMPORTANT Spray water over the windshield washer system on the windshield and switch on wiper at highest setting.
If there are problems:

Determine and rectify cause, subject to separate repair order.
 
8 Check setting of wiper arm on rear window MODEL 203.2/7, 211.2/6
NOTES
Wiper blade must not make contact with the liftgate.
Otherwise the liftgate or wiper mechanism may be damaged.
IMPORTANT Spray water over the windshield washer system on the rear window and switch on wiper at highest setting.
If there are problems:

Determine and rectify cause, subject to separate repair order.
 
9 Switch on low beam Vehicles with CODE 600 (Headlamp cleaning system) or with CODE 614 (Bi-xenon headlamp unit) or with CODE 615 (Bi-xenon headlamp unit with integrated curve illumination)  
10.1 Press HCS [SRA] switch (S1s1, S1s7) Vehicles with CODE 600 (Headlamp cleaning system) or with CODE 614 (Bi-xenon headlamp unit) or with CODE 615 (Bi-xenon headlamp unit with integrated curve illumination)
Vehicles with HCS [SRA] switch (S1s1, S1s7)
IMPORTANT The spray jet must impact in the light source area on the headlamp lens. Correct setting if necessary.
 
SPECIAL TOOL Adjusting tool
For clogged up spray nozzle:

Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice.
For spray nozzles that cannot be adjusted and with a deviating spray pattern:

Replace spray nozzle subject to separate repair order.
Fig 4
10.2 Repeatedly operate windshield washer system of windshield Vehicles with CODE 600 (Headlamp cleaning system) or with CODE 614 (Bi-xenon headlamp unit) or with CODE 615 (Bi-xenon headlamp unit with integrated curve illumination)
Vehicles without HCS [SRA] switch (S1s1, S1s7)
IMPORTANT Repeatedly operate windshield washer system for windshield until the headlamp cleaning system is activated. The spray jet must impact in the light source area on the headlamp lens. Correct setting if necessary.
 
SPECIAL TOOL Adjusting tool
For clogged up spray nozzle:

Clean spray nozzle using suitable needle and/or blow out with compressed air from inside out or replace spray nozzle subject to separate invoice.
For spray nozzles that cannot be adjusted and with a deviating spray pattern:

Replace spray nozzle subject to separate repair order.
Fig 4
11 Switch off low beam Vehicles with CODE 600 (Headlamp cleaning system) or with CODE 614 (Bi-xenon headlamp unit) or with CODE 615 (Bi-xenon headlamp unit with integrated curve illumination)  
12 Switch off ignition    
13 Correct the fluid level in the windshield washer system reservoir MODEL 203, 209 AP82.35-P-8210P 
MODEL 211
IMPORTANT Only for service with Plus package.
AP82.35-P-8210N 
Fig 4: Identifying Adjusting Tool (110 589 02 63 00)
G10038219Courtesy of MERCEDES-BENZ USA