General notes on touch-up applicators and paint spray cans - AH98.00-P-9409-06A

Model 124, 126, 129, 140, 163, 164, 166, 168, 169, 170, 171, 172, 201, 202, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 245.2, 251, 463 

Touch-up paint pens and paint spray cans are only suitable for temporarily touching up minor paint damage such as stone marks or scratches. They must not be used on the MB original paintwork repairs on the outer skin, since it is not possible to restore the original condition using this method.

Repairing minor paintwork damage 

With this kind of damage, and also in the repair of this damage, the entire paint structure is often damaged right down to the sheet metal.

For reasons of quality and corrosion protection, a primer must be applied before touching up the top coat in such cases.

Processing instructions are printed on the touch-up paint pens and in the leaflet provided inside the caps of the spray cans.

Touch-up applicators: 

• Primer applicator for metal parts 

  The cap contains a rust scraper which should be used to eliminate rust spots and loose paint.

• Top coat applicators for solid and metallic paints Body outer skin 

• Flat paint (glossy)
• Metallic paintwork set (metallic base coat and clearcoat, glossy)

  Plastic detachable parts 

• Flat paint for the colors 7129 galinite gray and 7167 deep dark gray (silk gloss)
• Metallic paintwork kit (metallic base coat and clear varnish) for contrasting colors for side moldings (silk gloss)

Paint spray cans: 

• Primer spray can for metal parts 

The cap contains a repair kit (rust scraper, abrasive paper and filler paste) for eliminating minor rust spots and other uneven areas.

Do not use for repairing plastic parts.

• Top coat spray cans (flat paint and metallic finish) Body outer skin 

• Flat paint
• Metallic paintwork set (metallic base coat and clear varnish)

Plastic detachable parts 

• Flat paint for the colors 7129 galinite gray and 7167 deep dark gray (silk gloss)
• Metallic paintwork kit (metallic base coat and clear varnish) for contrasting colors for side moldings (silk gloss)

For clearcoat systems with higher scratch resistance, observe the corresponding notes (Service Information).