Remove/install rear seat belts - AR91.40-P-0681SC
MODEL 216.3
Illustrated on left side of vehicle
| Remove/install | |||
|---|---|---|---|
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Risk of injury caused by release of spring in the automatic belt retractor is released. | Never disassemble automatic belt retractors. | AS91.00-Z-0002-01A | |
| Notes on performing repair, body work and welding on vehicles with airbags and ETR units | AH91.00-P-0002-01M | ||
| Assessment of airbag and belt tensioner units in accident vehicles | AH91.00-P-0006-01B | ||
| Legal regulations on handling and storing airbags and emergency tensioning retractors | AH91.00-P-0004-01A | ||
| 1 | Remove left and right paneling from C-pillar | AR68.30-P-4490SC | |
| 2 | Connect ground line to starter battery and to on-board electrical system battery | AR54.10-P-0003SX | |
| 3 | Unscrew bolt (5) from belt end fitting (6) | *BA91.40-P-1001-01O | |
| 4 | Remove bolt (2) from automatic belt retractor (1) | *BA91.40-P-1006-01O | |
| 5 | Disconnect left rear ETR squib connector (R12/6x1) or right rear ETR squib connector (R12/7x1) from automatic belt retractor (1). | ||
| 6 | Remove seatbelt (4) from belt guide and remove automatic belt retractor (1). | If the automatic belt retractor (1) is replaced, the faulty automatic belt retractor (1) must be disposed of properly. Refer to: ↓ |
|
| Notes on disposing of airbag and emergency tensioning retractor units | OS91.00-P-0001-01A | ||
| 7 | Install in the reverse order |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 216 | |
|---|---|---|---|
| BA91.40-P-1001-01O | Screw on belt end fitting | Nm | 32 |
| BA91.40-P-1006-01O | Bolt to rear inertia reel | Nm | 32 |