Adjust front module - AR62.30-P-1570-01SX
CHECK VALUES FOR GAPS
| Number | Designation | Model 216 up to model year 2011 | Model 216 as of model year 2011 | |||
|---|---|---|---|---|---|---|
| BE60.00-P-1001-01T | Gap dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (±0.5) | 3.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 3.5 (±0.5) | 3.5 (±0.5) | ||
| Engine hood to A-pillar | Dimension "D" | mm | 4.0 (±0.5) | 4.0 (±0.5) | ||
| Radiator grille/bumper | Dimension "C" | mm | 5.0 (±1.0) | 2.0 (±1.0) | ||
| Engine hood to bumper | Dimension "P" | mm | 5.0 (±1.0) | 5.0 (±1.0) | ||
| Bumper to headlamp | Dimension "Q" | mm | 3.5 (±0.5) | 3.5 (±0.5) | ||
| See picture | AR60.00-P-0700-01SC | AR60.00-P-0700-01SC | ||||
CHECK VALUES FOR GAPS
| Number | Designation | Model 221 | |||
|---|---|---|---|---|---|
| BE60.00-P-1001-01R | Gap dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 3.5 (±0.5) | ||
| Radiator grille/bumper | Dimension "C" | mm | 5 (±1) | ||
| Engine hood to bumper | Dimension "P" | mm | 5 (±1.5) | ||
| Bumper to headlamp | Dimension "Q" | mm | 3.5 (±0.5) | ||
| Bumper to fender | Dimension "R" | mm | 3.5 (±0.5) | ||
| See picture | AR60.00-P-0700-01SX | ||||
FRONT END ASSEMBLY WITH FRONT REINFORCEMENT
| Number | Designation | Model 216 | Model 221 | |
|---|---|---|---|---|
| BA62.30-P-1001-02F | Bolt connecting front end to longitudinal member | Nm | 55 | 55 |
| BA62.30-P-1002-02F | Bolt, outer reinforcement to fender bracket | Nm | 10 | 10 |
Shown on model 221
- Check and adjust gaps:
Engine hood to fender (A)
Engine hood to headlamp (B)
Engine hood to bumper (P)
Use feeler gauge.
Fine adjustment of the front module is possible only after completing the previously described operations.
- Loosen bolts (3) on left reinforcement (5) and right reinforcement (4).
- Loosen screws (2) on front end (1).
- Tighten all bolts loosened