Remove/install front bumper - AR88.20-P-2000H
MODEL 240
| Remove/Install | |||
| Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fire, sparks, naked flames or smoking. Wear protective gloves, acid-resistant clothing and safety glasses. Pour battery electrolyte only into suitable and appropriately marked containers. |
AS54.10-Z-0001-01A | |
| 1 | Disconnect battery ground line | AR54.10-P-0003H | |
| Notes on battery | All models | AH54.10-P-0001-01A | |
| Notes on AGM battery | AH54.10-P-0002-01A | ||
| 2 | Open | Engine hood and move to upright position | AR88.40-P-1000H |
| Risk of death . Death may result if vehicle slips or topples from the lifting platform | AS00.00-Z-0010-01A | ||
| 3 | Lift vehicle with lifting platform | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | |
| 4 | Detach lower | Engine compartment paneling | AR61.20-P-1105H |
| 5 | Remove front section of fender liner in front fender | AR88.10-P-1310H | |
| 6 | Unclip outside temperature display temperature sensor (B14) | ||
| 7 | Separate front PTS separation point (X26/27) | ||
| 8 | Unscrew bolts (5) and remove vent cover (4) | ||
| 9 | Unscrew bolt (6) of rear vent cover (4) | ||
| 10 | Unscrew bolts (7) from bumper (1). | ||
| 11 | Unscrew bolts (8) in front wheelhouse | ||
| 12 | Pull bumper (1) to the front out of the side guide | ||
| 13 | Install in the reverse order |