Remove/install wind deflector - AR77.20-P-2500SX

MODEL 221.0 with CODE (414) Power glass tilting/sliding roof 

MODEL 221.1, 216.3 

Shown on model 221.0 

Fig 1: Identifying Wind Deflector Remove/Install Components - Shown On Model 221.0

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Open tilting/sliding roof
2	Pull wind deflector (1) upward in center, simultaneously press downward at right and slide wind deflector (1) to right below roof paneling.	Carefully pull window deflector (1) upward, otherwise wind deflector (1) or guides (2) can be damaged. Helper required
3	Expose left height stop of wind deflector (1) using mounting wedge and then pull out right height stop	Helper required
			Fig 2
4	Position wind deflector (1) vertically and remove from guides (2).	Wind deflector (1) should be arrested horizontally in guides (2) to prevent damaging guides (2). Check left and right spring bracket (3) for proper seat.
5	Check guides (2), replace if necessary.
6	Install in the reverse order

Fig 2: Identifying Wedge Tool (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA