Legend of electrical function diagram for ignition system - PE15.12-U-2050-60FAB
ENGINE 272 in MODEL 204.0
| Item | Designation | Coordinates |
|---|---|---|
| A16/1 | Right knock sensor | 1F |
| A16/2 | Left knock sensor | 1F |
| B2/5 | Hot film MAF sensor | 6B |
| B2/5b1 | Intake air temperature sensor | 6B |
| B6/4 | Left intake camshaft Hall sensor | 2G |
| B6/5 | Right intake camshaft Hall sensor | 2G |
| B6/6 | Left exhaust camshaft Hall sensor | 2G |
| B6/7 | Right exhaust camshaft Hall sensor | 2H |
| B11/4 | Coolant temperature sensor | 2D |
| B28 | Pressure sensor | 7J |
| B37 | Accelerator pedal sensor | 4B |
| B70 | Crankshaft Hall sensor | 8C |
| Code 427 | 7-speed automatic transmission | 12C |
| M16/6 | Throttle valve actuator | 5K |
| N3/10 | ME-SFI [ME] control module | 5D |
| N10/1 | Front SAM control module with fuse and relay module | 12G |
| N30/4 | Electronic Stability Program control unit | 9G |
| R4 | Spark plugs | 1J |
| T1/1 | Cylinder 1 ignition coil | 4J |
| T1/2 | Cylinder 2 ignition coil | 4J |
| T1/3 | Cylinder 3 ignition coil | 4J |
| T1/4 | Cylinder 4 ignition coil | 4K |
| T1/5 | Cylinder 5 ignition coil | 4K |
| T1/6 | Cylinder 6 ignition coil | 4K |
| X11/4 | Diagnostic connector | 17H |
| Y3/8 | Fully integrated transmission control control unit | 13D |
| CAN C | Drive train CAN | 10D |
| CAN D | Diagnostic CAN | 14J |
| CAN E | Chassis CAN | 10F |
| 1 | Transmission control, status | 7E |
| 2 | Engine torque, reduce request | 7F |
| 3 | Correction programming, communication | 8F 12G 13H 15H |