Preparing Wheel Well Panel Front Section - Ar62.20-D-1280-04H

The following operation steps are shown on the left wheel well paneling front section (1) for model 906.733 and must be performed analogously on the right side if damaged.

1. Scribe separation line on wheel well paneling front section (1) (area A).

   Transfer dimensions from vehicle.

   Courtesy of MERCEDES-BENZ USA

2. Grind mating surfaces on wheel well paneling front section (1) down to bare metal in crosshatched areas.

   Grind spot weld flanges down to bare metal on both sides.

3. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA