Cut Out Outer Part Of End CROSSMEMBER - Ar64.20-D-1110-01H

The following operation steps are shown on model 906.633.

1. Expose weld seams on end crossmember external part (1) (areas A and B).
2. Cut weld seams on end crossmember external part (1) (areas A and B).

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

3. Expose spot welds on end crossmember external part (1) (areas C and D).
4. Mill off spot welds on end crossmember external part (1) (areas C and D).
5. Remove damaged end crossmember external part (1).
6. Grind mating surfaces on body down to bare metal in crosshatched areas.

   Grind spot weld flanges down to bare metal on both sides.

7. Remove shavings and drill chips.
8. Coat insides of spot weld flanges with zinc dust paint.

Courtesy of MERCEDES-BENZ USA